How-To

How to apply 3D metallics epoxy floor coating

With a few easy-to-follow instructions, anyone can apply our Epoxy Metallics product!

Any surface that is about to be sealed needs to be completely cured, clean and free of all contaminants, and fully profiled and etched. Moisture should also be limited as all Dura-Kote Metallics systems utilize non-vapor-permeable sealers or moisture and vapor barrier DK 700.

How To Cast And Install Stepping Stones

How to Cast Corner Molds DIY Instruction

To cast the corner mold, prepare the corner support from plywood or melamine. Flip the mold to the smaller end facing the floor, and cast it. Hold until concrete cures a little (it shouldn’t cure completely/ has to be fresh)

How to cast GlobMarble brick stone mold

BS 611 mold casting weight is about 12 lbs. - (5.45 kg.)

Always apply release agent to your mold prior to casting concrete. Recommended Sprayer.

1x2 cement to filler mix ratio. You can also mix 1-part Portland cement to 3 parts sand (filler), plasticizer and water has to be re-calculated by cement weight

How to Cast Mosaic Stone Mold

GlobMarble Mosaic mold average concrete casting weight is about 10 lbs, 1-part Portland cement to 3 parts sand. Plasticizer and water has to be re-calculated by cement weight

How to Make Concrete Stone Instruction

GlobMarble supplies professional grade casting molds which replicate the structure and relief of natural stone to the smallest details. Molds made of two-component polyurethane or silicone rubber proved their high quality and durability. When handled with care the molds life span last for years and allows making plenty of casts.

How to Set Up and Use Concrete Countertop Edge Forms

Edge Form setup, removal & cleaning. Edge Form can be curved to form a radius edge. Make the curve radius large enough to ensure a smooth, consistent edge detail and prevent Edge Form to distort or ripple. Edge Form can be cut with sharp razor knife to fit tightly in your form

How to Stamp Concrete

Stamped Concrete is the process of pressing natural stone impressions into wet concrete using rubber stamp mats. This is a great way to create a unique flair to exterior or interior project including pool decks, walkways, driveways, patio, or walls.